Home Atlatl HV
Atlatl HV
FPV Racing Drones
Since the late September, the pit mode outputs on both Atlatl HV and Kopis 1 have been changed into 0.5mw.
Compatible with all major FPV receivers from vendors such as Fatshark, ImmersionRC, etc.

Supports the standard 40-channel set: band A, B, E, Fatshark, and Raceband.

Telemetry input allows remote control by the flight controller (where supported). Change channel, transmit power, and more from Betaflight OSD, flight controller USB port, Taranis, and more.

Variable transmit power from 25 mW to 600 mW. Use 25 mW for a race and then easily switch to 600 mW for freestyle.

Pit Mode allows you to power up safely without the risk of knocking other pilots out of the air.

Mono audio input allows you to install a microphone, so you can listen to your motors while you fly, no matter how far away you fly.

Standard 36mm form factor allows you to mount the Atlatl directly in your flight controller stack.

Package Includes
VTx Board *1

Heat sink *1

80mm SMA--MMCX Cable *1

150mm 4pin JST GH wire *1

Spec
Output Power: 0.5 mW (pit mode), 25 mW, 100 mW, 200 mW, 400 mW, 600 mW

Audio: 6 MHz + 6.5 MHz Mono

Antenna Connector: MMCX

Input Voltage: 7 to 42 volts (2-6S LiPo)

Dimensions: 35x35x7mm

Mounting Holes: Standard 30.5mm square to center of holes 

Weight: 10.8g

Recommended Products