Home Kakute
Kakute
Flight Controller
Recessed, sideways pin headers. Also enables soldering of all wires directly to pads without use of any pin headers.Dedicated Boot button for easy firmware flashing.Reinforced solder pads for trouble-free direct soldering.Extremely low profile design.Input voltage 7v to 42v. Power the board directly from flight pack up to 6S (on 'BAT' pad only!).

VIN + VBAT merged - A single wire to power the board will provide voltage input and Telemetry/OSD voltage data.Filtered voltage output - output 5v 800mA (and 3.3v 150mA where applicable) to power peripherals such as GPS, RX, BLACKBOX, OSD. 5v/3.3v RX selectable.Cleanflight support (RACE target).BLHeli flashing supported by hardware,Raceflight ready,Betaflight ready

Package Includes
1x Kakute Flight Controller

1x 2.54mm Pitch pin headers

Quick Start Guide

Spec
STM32F303CCT6(256kB flash) 32-bit processor

MPU6050 Gyro/Accelerometer

High quality, gold plated PCB

Micro USB connector for programming

Dimensions: 36x36x6mm (includes USB in height)

Mounting Holes: 30.5mm square to center of holes

Weight: 4.2g

Recommended Products