Home CC3D
CC3D
Flight Controller
The CopterControl & CC3D boards are all-in-one stabilization hardware which runs the OpenPilot firmware. They can fly any airframe from fixed wings to octocopters and are configured and monitored using the OpenPilot Ground Control Station (GCS) software.

Package Includes
CC3D Board * 1

JST-SH 8pin cable *1

JST-SH 4pin cable *2

Spec
MCU: STM32F103CBT6,STM32 ARM-based 32-bit MCU with 128 Kbytes Flash

3-axis Gyroscope& Accelerometer : MPU6000

Supports several common RC inputs: 6 PWM channels, combined PPM, Spektrum/JR DSM2, DSMJ, DSMX satellites, and Futaba S.Bus receivers

Simultaneous support for multiple receivers

ReceiverPort functions (configurable): 6 PWM input channels or combined PPM stream, 4 PWM output channels

MainPort functions (configurable): serial telemetry (default), GPS, S.Bus, Spektrum/JR satellites

FlexiPort (configurable): serial telemetry, GPS, Spektrum/JR satellites, or I2C peripherals (under development)

10 PWM outputs to servos or ESC's, or for camera stabilization

Camera stabilization: supports up to 3-axis camera mounts with stabilization and manual control from any of configured receivers

Onboard USB connectivity for easy configuration

USB and serial telemetry and configuration (including wireless with optional radio modules)

Supported by powerful OpenPilot GCS

4 Mbit onboard memory

3C Quaternion based complementary filter running at 500Hz

Dimension:36*36mm

Mounting holes:30.5*30.5mm

Weight:8.5g(without cable)

Recommended Products